10CC HEAT TRANSFER COMPOUND SYRINGE - CHEMTOOLS
Non-toxic silicone heat transfer compound, in handy useto use applicator, exhibits high thermal conductivity, non creep, suitable for use with power diodes, transistors and other devices.
Maintains a positive heat sink seal that improves heat transfer from the device to the heat sink chassis, thereby increasing overall efficiency of the heat dissipation.
ChemTools Heatsink Compound is a non-toxic, metal oxidefilled silicone grease, which provides a highly efficient and highly thermally conductive compound designed to operate over a wide temperature range.
10cc Syringe
Features:
- High Thermal Conductivity.
- Non-Electrically Conductive.
- Wide Operating Temperature Range.
- No Creep and Low Bleed Characteristics.
- Easy Application, Low Toxicity, Economic.
Physical Properties:
- Appearance: White Paste
- Odour: None
- Thermal Conductivity: 0.9 W/mK
- Density: 2.2 g/cm3
- Temperature Range: -100 to +200°C
- Weight Loss: <1% after 96hrs @ 200°C
- Dielectric Strength: 42kV/mm
- Electrical Resistance: 1012
INFORMATION:
Heat sinks operate by conducting heat from the processor to the heat sink and then radiating it to the air. The better the transfer of heat between the two surfaces (the CPU and the heat sink metal) the better the cooling. Some processors come with heat sinks glued to them directly, ensuring a good transfer of heat between the processor and the heat sink.
Heat sinks that are attached using clips normally sit rather loosely on top of the processor. It may feel like it is attached securely, but there will be a gap between the CPU and the heat sink, and that gap of air them makes for poor heat transfer, even if it is very small. Air is apoor conductor of heat compared to most liquids or solids.To improve the thermal connection between the processor and heat sink, a special chemical called heat sink compound should be used. A thin layer of this is spread between the two, which greatly improves heat transfer and the cooling of the processor.
Heat sink compound is a white paste made from zinc oxide in a silicone base. Very little of the substance is needed, just enough to fill the gap between the CPU and heat sink. Using more will not make it work better, it will just make a big mess when you press the heat sink down onto the CPU, much like putting too much strawberry jam inyour PB&J sandwich.
The use of this compound is strongly recommended for those who want to cool their processors properly.
Weight: 0.022
Aussie Stock
All our stock is kept in our Melbourne based warehouse. Our stock levels are also updated every 10 minutes! So if it says 10 units in stock, you can trust that it is accurate.
No PO Boxes or Parcel Lockers
At this stage we only use couriers and can only deliver to a road-side address. This means PO Boxes and Parcel Lockers cannot be accepted as StarTrack do not deliver to these addresses.
In instances where a PO Box or Parcel Locker address in entered, we may ask for an alternative road-side address, or cancel and refund your order immediately and urge you to replace your order with an alternative delivery address.
Delivery times
We typically dispatch our goods same day or next day. From there, you can expect 2 - 8 business days Australia wide. Most capital cities can expect 1-2 day delivery times.
Any RTS (Return to Sender) orders due to missing or incorrect address information entered by the buyer may incur an additional charge for redelivery.