WattStopper IR Energy Saving Power Board (ESB-001)

Specifications:

• WattStopper,trade; IR Sensor Controlled Energy Saving Power Board for Home Entertainment Systems
  
  • Model No: ESB-001
• Features:
  
  • Energy Saving: The WattStopper,trade; eliminates ,lsquo;standby,rsquo; power wastage by automatically switching off all home entertainment,nbsp; systems, thus extending equipment operating life in addition to significant savings on electricity costs. The WattStopper,trade;,nbsp; IR( infrared light) Sensor when coupled with the primary remote controller( possibly the TV remote) automatically switches of all the components and saves your energy theft.
  • Purchase Price Recovered: The WattStopper,trade; quickly recovers its purchase price by reduced electricity usage.
  • Power Surge Protection: The WattStopper,trade; provides 24hr protection against damaging power surges.
  • Easy Set Up without Tools: The WattStopper,trade; takes only a few minutes to set up without the need for special tools or computer software.
  • Reduced Fire Risk: The potential risk of equipment overheating and electrical fire is reduced by the use of the WattStopper,trade;
  • Electrical Safety compliance (Approval No- V07946): AN/NZS 4251.1:1999, AS/NZS 3197:2005, AS/NZS 60950.1:20 Incl Amdt 1 and Selected Clauses of AS/NZS 3112 , AS/NZS 3100
  • Extends equipments operating life
  • 24 hour protection for connected equipments against power surge and spikes
• Product Specifications:
  • Voltage Rating: 230V -240V AC 50Hz
  • Current Rating: 10A
  • Cord Length: 1m
  • Maximum Energy Dissipation: 449.4 Joules
  • Response Time: ,lt; 1 Nano Second
  • Maximum Current Spike: 13,500 Amps
• Easy Setup Process:,nbsp;
  
  • Pairing Entertainment System,rsquo;s Primary Remote Controller with IR Eye
    
    • Step 1: Plug the Energy Saving Power Board into a 240 volt earthed outlet and turn on. If the Red Status Light comes on press the Control Button to turn it off
    • Step 2: Press and hold the Control Button on the Power Board for 3 seconds until the red Status Light starts to blink at a fast rate
    • Step 3: While the Status Light is blinking at a fast rate hold the primary remote controller for the entertainment system 1 metre from the IR Eye of the Energy Saving Power Board and press the on/off button on the remote controller.
    • Step 4: The Status Light will respond by blinking at a slower rate for approximately 3 seconds and then will resume blinking fast.
    • Step 5: Repeat Step 3 two (2) more times. After the third time the Status Light will stop blinking. Your Remote Controller is now paired and programmed with the IR Sensor of the Energy Saving Power Board and now paired
  • ,nbsp;Locating the IR Sensor Eye:
    
    • Step 1: The IR Sensor,rsquo;s Eye must be positioned to allow direct and uninterrupted access of the IR output signal from the remote controller to the IR Eye.
    • Step 2: The 135 cm IR Sensor lead allows the Eye to be conveniently positioned on a wall behind the entertainment system or on one of the system components
    • Step 3: An adhesive ,lsquo;dot,rsquo; is attached to the back of the IR Eye. When you have selected the position to mount the IR Eye, remove the protective backing tape from the adhesive ,lsquo;dot,rsquo;, and firmly press IR Eye onto the surface where you wish to position it