1:1 Epoxy Resin Casting Ultra Clear Craft Mica Powder AB Kit Coating Paste DIY
2 Reviews
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
Collect 19 Everyday Rewards points
2 Reviews
Collect 19 Everyday Rewards points
Our epoxy resin Produces a tough,No VOCs,Low Odor, high gloss,water and scratch resistant and yellowing coating. transparent epoxy resin is strong,transparent and fully UV resistant hard as a rock ensuring your artwork and DIY projects Durable.
Quantity: 2 Pcs
Color: Crystal Clear
Material: Resin
Uses: crystal epoxy production, cos equipment production, RC boat production, DIY glass steel works, reinforcement, etc.
Highly transparent, non-yellowing, automatic defoaming
You can make rings, bracelets, pendants, etc. with our glue
You can experience the fun of handcrafting and creativity
Usage:
1. Mixed two bottles: A : B = 1:1 ratio(volume ratio).
2. Stirring must be uniform, especially the inner wall of the container, the bottom, etc., about 5 minutes.
You can use glass rods, bamboo sticks, etc. After mixed,this product is better to let stand for 3-5 minutes
before used in order to break the bubbles which produced when it was mixing in time.
3. Please try a little bit before using the product a lot, so that would master the skills and avoid mistakes.
4. When using crystal glue, be careful not to stick it on your hands or body. If this happens, wipe off the glue with a cloth or paper towel, then rinse with water soap or detergent.
Question:
Q:Why are there bubbles in the finished product?
A:Stir too fast when adjusting the glue, and pour into the mold before the bubbles have completely subsided. Or after pouring the glue into the mold, the inner wall of the mold is not observed. If there are bubbles, please cut them off in time.
Q:Why is the finished product soft?
A:Inaccurate adjustment of the glue ratio will cause the finished product to not solidify, and the glue will not be thoroughly mixed evenly during stirring, and there will be wire drawing in the glue, and the mold will be demolded if it is not completely solidified.
Q:What should I do if I get Epoxy?
A:It can be washed directly with water, or wiped with a nail remover towel before washing.
Q:Can it be put in the sun or in the refrigerator?
A:Do not expose to the sun for a long time. Excessive exposure to ultraviolet rays will make the finished product fade and yellow. Putting glue in the refrigerator will greatly extend the fixed time.
1 x A Epoxy Resin
1 x B Epoxy Resin
1 Pair of gloves
4 x Stirring rod
2 x Measuring cup
"
Estimated Delivery Time Frame:3-7 business days
Ask a Question About This Product
Reference ID: 9580720