Introducing the innovative 18-Pin Microneedle Cartridge, an exclusive addition available only on the latest Dr. Pen products. This cartridge is part of the comprehensive range of M8S microneedling cartridges, offering seven distinct options, with the 18-pin cartridge specifically designed to enhance skin texture and reduce the appearance of fine lines.

The 18-Pin Microneedle Cartridges are perfectly suited to address various skin concerns on the face, including:

1. Improving skin texture



2. Diminishing wrinkles and fine lines



3. Treating acne scars and other types of scarring



4. Addressing hyperpigmentation



5. Assisting with sun damage



6. Evening out skin tone

The Dr. Pen M8S Microneedling Pen boasts exceptional features, including:

1. Specially constructed 18-pin cartridge with a diameter of 0.18mm and an N-shape line design that closely mimics skin texture.



2. Addition of a wavy contact surface for enhanced absorption of skincare products.



3. Built-in three bayonet edge for safeguarding the device.



4. Easy connectivity with the M8S pen.



5. Fine gauge needles made of high-quality stainless steel.

What's Included

• 
  10x pack of 18-pin Microneedle Cartridges for Dr. Pen M8S Microneedling Pen
  

DO NOT USE

• On open wounds



• On broken skin



• On active acne



• Or continue to use if irritation occurs

Important: Microneedling cartridges must be sterilised before each use to ensure the treatment is safe and hygienic. It is essential to follow these steps carefully to ensure that the microneedling cartridges are properly sterilised. Here are the steps to sterilise microneedling cartridges:

1. First, ensure that you have all the necessary equipment for sterilisation; gloves, isopropyl alcohol solution (70% or above) and a clean container to hold the solution.



2. Put on your gloves to avoid contaminating the cartridges during the sterilisation process.



3. Check on your cartridge; ensure the needles are in perfect condition (i.e. not bending) and remove any debris.



4. Pour enough alcohol solution into the container and dip the cartridge needle into a sterilisation container, then soak for a couple of minutes.



5. If you have alcohol solution in a spray model, you can spray it towards the needle head of the cartridge.



6. Once the sterilisation is complete, allow the cartridge to air dry before using it.



7. Finally, your cartridge is ready for use.

How to Use

1. Remove the sterile cover on the top of the cartridge



2. 
   Connect the cartridge to the Dr. Pen M8S Microneedling Pen
   



3. After double-cleansing the face, tie back your hair



4. Apply Femvy Hyaluronic Acid serum in the desired small areas



5. Turn the device on, and set the depth and speed for the treatment



6. Then slowly start the treatment in a cross-hatch pattern



7. Use light pressure and ensure not drag/pull the skin



8. Dispose of your microneedling cartridge safely after one treatment, do not re-use

Usage

Perform your microneedling treatment only once every 4-6 weeks

Disclaimer

Please speak with your doctor before purchasing any Dr Pen products. The content on this site is not intended to substitute for the advice of a qualified physician, pharmacist, or other licensed healthcare professional. The products may have additional information and instructions on or inside the packaging that you should carefully read and follow. Contact your healthcare provider immediately if you suspect that you have a medical problem. This product may not have been evaluated by the Food and Drug Administration and is not intended to diagnose, treat, cure, or prevent any disease or health condition. For any concerns or questions, please contact your GP or dermatologist.