AOSept Plus with HydraGlyde is a preservative-free, aqueous(hydrogen peroxide 3%) Contact Lens Care solution that cleans, disinfects, neutralises (minimum soak time 6 hours), removes protein and stores all types of contact lenses including silicone-hydrogels.

hydrogen peroxide 3%, phosphonic acid (stabiliser), sodium chloride, phosphate (buffer system), poloxamer (surfactant), HydraGlydeTM Moisture Matrix (EOBO-21TM – polyoxyethylene-polyoxybutylene), and purified water.

Usage Instructions: NEVER put AOSEPT™ PLUS with HydraGlyde™ Solution into your eye OR onto a contact lens immediately before inserting the lens into your eye. Otherwise, burning and stinging will result.

1. Wash your hands and dry them with a clean, lint free towel.

2. Open the lens holder marked “L”, remove your left lens and place it on the dome. Close lens holder taking care to avoid trapping your lens.

3. Repeat procedure with your right lens placing it on the dome of the other lens holder marked “R”.

4. Open the fl¬ip top cap on the AOSEPT™ PLUS with HydraGlyde™ bottle and bend it back and out of the way.

5. Thoroughly rinse the lenses in the lens holders with AOSEPT™ PLUS with HydraGlyde™ for 5 seconds.

6. Fill the cup with AOSEPT™ PLUS with HydraGlyde™ solution to the fill line. DO NOT UNDERFILL OR OVERFILL

7. Place lens holder in the lens cup and screw closed. Do not over tighten the AOCup lens case (only tighten finger tight). DO NOT SHAKE THE LENS CASE.

8. Store lens case upright - If bubbles leak from the hole in the top of the lens case’s cap, non-neutralised AOSEPT™ PLUS with HydraGlyde™ Solution may be present. Empty the solution from the lens case and wash off any spillage from the surface on which the AOCup lens case was standing. Thoroughly rinse the lens cup and lens holder with sterile saline. If spillage occurs, clean up immediately with a paper towel. Wash your hands thoroughly before handling your lenses or touching your eyes. REPEAT THE DISINFECTION PROCEDURE ABOVE.

9. Allow lenses to soak for a minimum of 6 hours or overnight to neutralise solution.

10. After washing, rinsing and drying your hands, remove your lenses from lens holder

11. If desired or recommended by your eye care professional: Rinse lenses before insertion with STERILE SALINE after neutralisation. Do not use AOSEPT™ PLUS with HydraGlyde™ Solution to rinse lenses before insertion.

12. Your lenses are now ready to wear.

13. Discard used solution, rinse the lens cup and lens holder with sterile saline - DO NOT USE TAP WATER OR OTHER NON-STERILE LIQUIDS.

14. Allow them to air-dry by inverting the lens holder outside the cup. Do not place the lens case on its side.

15. If you do not intend to wear your lenses immediately after disinfection/neutralisation, you may store them in the neutralised AOSEPT™ PLUS with HydraGlyde™ Solution, in the unopened AOCup lens case for up to 14 days. After this time, your lenses must be cleaned and disinfected with AOSEPT™ PLUS with HydraGlyde™ Solution prior to wear.

Usage Advice:

• Always wash, rinse and dry your hands before handling your lenses.
• TAMPER EVIDENT: Do not use if security seal around the bottle cap is damaged or missing prior to first opening.
• Do not use if package or bottle (sterile packaging) or lens case is damaged.
• Tightly close the flip top cap on bottle after each use.
• Use before the expiration date marked on the product.
• Once the bottle is opened, discard any remaining solution after three months.
• To avoid contamination, never touch dropper tip of the bottle to any surface.
• Always use the new AOCup lens case provided with each bottle/purchase of AOSEPTTM PLUS with HydraGlydeTM Solution.
• Do not change lens care solutions without consulting your eye care professional.
• Do not use if you are allergic to any of the ingredients.
• Never use AOSEPT™ PLUS with HydraGlyde™ for heat disinfection.

• Do not store above 25°C.
• Always use AOSEPT™ PLUS with HydraGlyde™ Solution between 15°C and 25°C as neutralisation below 15°C may take longer than 6 hours.
• Store out of direct sunlight.