,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
Follow these step-by-step directions when using E6000:
1. Please read all directions and test small area before use.
2. Surface should be clean, dry, and free from dirt. For best results, lightly roughen surface before use.
3. Screw precision tip into top of tube cap. Replace with fresh tip as needed.
4. Apply directly to surfaces to be bonded or repaired. Allow 24 hours for curing.Maximum bond strength may not be reached for up to 72 hours.
5. For future easy cap removal, apply a thin coat of petroleum jelly to the threads of the tube before replacing the cap. Clean uncured adhesive with acetone or citrus-based solvents.
Specifications:
NOTE: E6000 IS NOT RECOMMENDED FOR USE ON STYROFOAM, POLYSTYRENE, POLYETHYLENE OR POLYPROPYLENE PLASTICS
*Safety Note: (important )
This item carries cancer agents warnings according to the state of California USA
Full ventilation is recommended when using and drying the product.
Vapors may cause nausea and headaches.
Reference ID: 7467348