Online Deals by MyDeal

Enjoy up to $0 off your order by spending your Everyday Rewards dollars

LED LOAD RESISTOR 12V TWIN PACK Bullbar lights front & rear indicators

Image 1
$35.20

Collect 35 Everyday Rewards points

Log in to MyDeal to link your card
Free Shipping

Dispatch in 2 business days

Sold & shipped by Auto 8
Secure ways to pay at checkout

Are Your indicators flashing too fast after you have installed LED indicators? These resistors are an easy fix for the problem.
Indicators that are flashing too fast are caused by low current draw through the flasher unit; when you remove a 21watt globe and replace it with a LED light, the LED will not draw sufficient current to activated the flasher unit correctly. When resistors are installed they will draw the same current as the 21watt globe and there for flash at the correct speed.

This Listing is for a Pair of LED load Resistors (pack of 2) (12 volt) to fix Indicators flashing too fast After Fitting LED Lights.
They are easy to install; Just connect one wire to Negative (Earth or Ground) and the other wire to the indicator positive wire. You need to install one resistor on each side (one on Left & one on Right) and the wiring from the resistor can be connected either way (ex. it does not matter which wire is negative or positive so you cannot connect it the wrong way  as is the case with many of the resistors on the market). 

MPN: AP19012-2

Estimated Delivery Time Frame:1-6 business days

Ask a Question About This Product

Reference ID: 7037894