Water Suction Pump Electric Drill Driving Large Flow Micro Pumping Tool Black Other Pump Parts & Accessories
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
,gravity=Center,allowExpansion)
Collect 19 Everyday Rewards points
Collect 19 Everyday Rewards points
Sold by HOD HEALTH AND HOME Australia
Your parcel will also be fully insured and trackable
The Flow Rate Is About 1800 M3/H And The Maximum Speed Is Recommended To 3000-4000 Rpm.
Working Temperature 5 - 49Deg.C (41-120Deg.F) Tube Inner Diameter 15Mm
Installed On The Electric Drill Fully Automatic No Battery Corrosion-Resistant Water Sewage Etc.
Using Instruction
1. In Order To Achieve Pump Start-Up And Prolong Service Life Add A Small Amount Of Lubricant To The Pump Inlet Before Use And Rinse With Water After Each Use.
2. Make Sure The Inlet Hose Is Sealed As Short As Possible And The Hose Should Not Exceed 9 Feet ( 2.75 Meters).Br>3. Working In The Temperature Range Of 5 - 49 Deg.C
4. When Pumping Solids-Containing Abrasives Or Liquids Use Filters On The Inlet Lines For Longer Pump Life.
5. It Is Recommended To Install The Pump On The Surface For Safe Use.
6. Install And Start The Rig. Observe That The Inlet Pipe Has A Certain Amount Of Fluid That Is Drawn Into The Pump Within 15-20 Seconds. If Not Check That The Inlet Pipe Is Properly Installed On The Pump. Don't Work. If The Pump Fails To Start Check The Hose For Kinks Or Blockage. The Pump Depends On Whether The Fluid Is A Pump For Lubrication
Note: Do Not Run The Pump In Reverse.
Warning: Do Not Operate The Main Process Drilling Pump Or Allow The Power Cord To Fall Into The Water While Standing In The Water. Always Stand On A Dry Floor And Keep All The Codes Dry.Div>Specificatio
Estimated Delivery Time Frame:12 - 20 Business Days
Ask a Question About This Product
Reference ID: 9618547