-ITC-306 (HEATING ONLY) is a pre-wired heating output temperature controller with time function specifically for breeding and planting.

-Can be set to two different temperatures with its function of dual time cycle setting during 24 hours according to the day and night can more suitable for the physiological needs of animals and plants.

-Can be widely use in over-heat protection and automatic temperature control system of all sorts of electrical equipment for aquarium, pets breeding, hatching, fungus fermenting, and seed germination accelerating, etc.

-This plug and play product is designed with dual LCD display, and offers the optional display of Centigrade or Fahrenheit, makes it more humanized temperature control.

• Plug and play design, easy to use;
• Dual time cycle setting during 24 hours, can be set different temperature from day and night on the basis of the physical needs of animals and plants.
• Support Centigrade or Fahrenheit unit reading modes.
• Maximum output load: 2400W.
• Dual display window, be able to display measured temperature and set temperature at the same time;
• Temperature calibration;
• Over-temperature and sensor fault alarm

• Temperature Control Range: -50~99 °C / -58~210 ° F
• Temperature Resolution: 0.1 ° C / 0.1° F
• Temperature Accuracy: ±1°C (-50 ~ 70°C) / ±1°F (-50 ~ 160° F)
• Temperature Control Mode: On/Off Control, Heating(only)
• Input Power: 100 ~240VAC, 50Hz/60Hz
• Temperature Control Output: Max.10A, 100V ~240V AC
• Sensor Type: NTC sensor (Including)
• Sensor Length: 2m / 6.56ft
• Input Power Cable Length: 1.5m (5ft)
• Output Power Cable Length: 30cm (1ft)
• Dimension: Body: 140x68x33mm (5.5x2.7x1.3inch)
• Socket: 85x42x24mm (3.3x1.7x1inch)
• NET Weight: About 0.35kg (0.77lb)
• Ambient Temperature: -30~ 75 ° C / -22~ 167 ° F
• Storage: Temperature: -20~ 60 ° C / -4~ 140 ° F
• Humidity: 20~85% (No Condensate)
• Warranty: 1 Year

• 1 x ITC-306T temperature controller;
• 1 x Manual

temperature controller is a pre-wired heating thermostat with a timing function, especially for reptile breeding, incubation, and cultivation.

This heating thermostat can be set to two different temperatures with its dual function timing cycle for 24 hours after the day and night, which may better suited to the physiological needs of fish and aquarium plants.

This thermostat has overheating protection and automatic temperature control for all kinds of electrical equipment for the greenhouse heater, and heat mat.

With a dual LCD display, the temperature controller offers an optional display of Celsius or Fahrenheit, allowing humanized temperature control.

The dual heating thermostat has Temperature calibration, the temperature may become more accurately controlled with its function of temperature calibration and temperature hysteresis.

Plug & Play design, easy to use. Just plug the heater in sockets at the ITC-306, and set your desired temperature to be ok.

Temperature range: -50~99 °C / -58~210 ° F. Maximum total output load: 2200 W (220 V). Input Power: 100 ~240VAC, 50Hz/60Hz. Temperature Control Output: Max. 10A, 100V ~240V AC