Whether it’s yours or your neighbours, the noise can almost drive a person bonkers. So for peaceful day and nights, invest in one of these ultrasonic anti-barking devices. No need for a collar, this weatherproof device can be mounted on a tree, pole or fence outside and it will detect barking noise in a 15m range.
Suitable for dogs of all sizes and barking sounds, this handy device emits a harmless sound to control barking noises and features LED lights to indicate that it is working. Set one up in your yard today and never worry about getting complaints or making complaints about barking nuisance again!
Uses ultrasonic sound to deter barking
Emits a harmless but effective sound to control barking
Suitable for all sizes of dogs
Detects the sound of barking up to 15 metres
Four levels of operation including test mode and 3 range levels
Power: 9V Battery (not included)
Durable and weatherproof for outdoor use
Easily mount to any wall
LED power indication
Dimensions: 9.9 x 6.4 x 11.55 cm
Important Note: The efficiency of the Ultrasonic Bark Device depends on the dog itself, as all dogs are different. It will usually work within a few days, but it will also depend on the time period it takes for the dog to associate the ultrasound with their barking. Maximum efficiency is approximately 2-3 weeks when the dog should be conditioned.
How to Operate the Ultrasonic Dog Bark Control
Installation and Setup The Ultrasonic Bark Device should be placed facing the dog and within range of the dog. It should be positioned at a height of no more than 1.5 meters. It can be placed in a tree, hanging from a pole, on a fencepost etc. For best results, the area between the Ultrasonic Bark Device and the dog should be free of any large obstacles.
Change battery The Ultrasonic Bark Device utilizes a replaceable 9-Volt battery. The battery is good, the green LED flash 1 time per 5 seconds. If the battery is low, the LED flash frequently. If there is no LED light it is time to change the battery.
Modes of Operation Begin use of the Ultrasonic Bark Collar with Low Range (“1”) mode, if the dog does not respond, increase to the Medium Range (“2”). If the dog does not respond to the Medium Range (“2”), increase to High Range (“3”). Turn to Test mode to verify the Ultrasonic Bark Collar work properly.
Test the Ultrasonic Bark Device Turn the Mode Switch to “T” Hold the unit with the Indicator Light towards you. The unit should be arms length away from your mouth. In order to activated the unit, say “Woof” loudly towards the Microphone. The LED light will flash red and there will be an audible sound to indicate that it is functioning properly. Return the Mode Switch to Low Range “1” before you begin using the ultrasonic device