Safety Information:

Safety Message Conventions Used

!?DANGER

!?WARNING

!?WARNING

!?CAUTION

? ?For your own safety and the safety of others, and to prevent damage to the equipment and vehicles, read this
manual thoroughly before operating your OBDII Diagnostic Tool. The safety messages presented below and throughout
this user manual are reminders to the operator to exercise extreme care when using this device. Always refer to and
follow safety massages and test procedures provided by vehicle manufacturer. Read, understand and follow all safety
massages and instructions in this manual.

We provide safety messages to help prevent personal injury and equipment damage. Below are signal words we used
to indicate the hazard level in a condition.

Important Safety Instruactions

And always use your OBDII Diagnostic Tool as described in the user manual, and follow all safety messages.

* Do not route the test cable in a manner that would interfere with driving controls.

* Do not exceed voltage limits between inputs specified in this user manual.

* Always wear ANSI approved goggles to protect your eyes from propelled objects as well

as hot or caustic liquids.

* Fuel, oil vapors, hot steam, hot toxic exhaust gases, acid, refrigerant and other debris

produced by a malfunction engine can cause serious injury or death.Do not use the OBDII Diagnostic Tool in areas where explosive vapors may collect, such as in below-ground pits, confined areas, or areas that are less than 18 inches (45 cm) above the floor.

* Do not smoke, striking a match, or cause a spark near the vehicle while testing and keep

all sparks, heated items and open flames away from the battery and fuel/ fuel vapors as they are highly flammable.

* Keep a dry chemical fire extinguisher suitable for gasoline, chemical and electrical fires in work area.

* Always be aware of rotating parts that move at high speed when an engine is running and

keep a safe distance from these parts as well as other potentially moving objects to avoid serious injury.

* Do not touch engine components that get very hot when an engine is running to avoid severe burns.

* Block drive wheels before testing with engine running. Put the transmission in park (for

automatic transmission) or neutral (for manual transmission). And never leave a running engine unattended.

* Do not wear jewelry or loose fitting clothing when working on engine.