Online Deals by MyDeal

Enjoy up to $0 off your order by spending your Everyday Rewards dollars

4Pcs 3D Printer Flat Bed Die Springs Level Upgrade Kit Ender 3 Pro V2 Cr-10 Cr-X

Image 1
Image 2
Image 3
Image 4
Image 5
Image 6
Image 7
Image 8
Image 9
Image 10
Limited Stock
$8.92

Collect 8 Everyday Rewards points

Log in to MyDeal to link your card
Take 10% Off Purchases Over $40
Exclusive to Aimall Pty. Ltd. products only. Expires 11.59pm 31/08/2025. Excludes Shipping.
Sold & shipped by Aimall Pty. Ltd.
Secure ways to pay at checkout

This is one of the best upgrades you can do to your printer.
The 25mm length is the correct spec for the spring - years ago, people used 20mm springs, but those can be too short in some cases.
Note for the Ender 3 V2: If you have trouble fitting the springs, raise the Z Stop just a touch. It may have been installed too low.
The Z Stop is the limit switch attached to the upright on the extruder side.
Each item consists of a set of 4 springs.

NOTES

Please allow a 1-3 cm difference due to manual measurements.
Please note that slight colour differences should be acceptable due to the light and screen.

GTIN: 9360101003500

Estimated Delivery Time Frame:2-10

Ask a Question About This Product

Reference ID: 14148113